Lan Ip Screen - ZyXEL Communications WAP3205 User Manual

11.4 LAN IP Screen

Use this screen to change the IP address for your WAP3205. Click Network >
LAN > IP.
Figure 64 Network > LAN > IP
The following table describes the labels in this screen.
Table 42 Network > LAN > IP
LABEL
Get from DHCP
Server
Use Defined LAN
IP Address
IP Address
IP Subnet Mask
WAP3205 User's Guide
DESCRIPTION
Click this to deploy the WAP3205 as an access point in the network.
When you enable this, the WAP3205 gets its IP address from the
network's DHCP server (for example, your ISP or router). Users
connected to the WAP3205 can now access the network (i.e., the
Internet if the IP address is given by the ISP or a router with Internet
access).
The Web Configurator may no longer be accessible unless you know
the IP address assigned by the DHCP server to the WAP3205.
Otherwise, you need to reset the WAP3205 to be able to access the
Web Configurator again (see
how to reset the WAP3205).
Also when you select this, you cannot enter an IP address for your
WAP3205 in the field below.
Click this if you want to specify the IP address of your WAP3205. Or if
your ISP or network administrator gave you a static IP address to
access the network or the Internet.
Type the IP address in dotted decimal notation. The default setting is
192.168.1.2. If you change the IP address you will have to log in again
with the new IP address.
The subnet mask specifies the network number portion of an IP
address. Your WAP3205 will automatically calculate the subnet mask
based on the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the WAP3205.
Section 12.7 on page 127
Chapter 11 LAN
for details on
117