Installation - Preparation - CDA HN6850FR Manual

Installation - Preparation

Unpacking the hob:
Take care not to drop any parts.
Fitting position of the hob:
This appliance must be installed in
accordance with the dimensions
given in Fig.8 on page 28 of this
manual and a minimum of 55mm
away from any adjacent vertical
surfaces, e.g. a tall cupboard end
panel. This may be reduced to 50mm
if the adjacent surface is resistant to
fire (tiles or steel for example). These
dimensions are shown in Fig.8 on
page 28.
Ventilation requirements:
This appliance must be installed to
allow air to flow freely to the air intake
and from the air outlet. An air gap of
25mm is recommended immediately
below the hob (minimum of 10 with
oven below).
Failure to allow sufficient ventilation
could cause problems with operation
or damage to the hob and constitutes
incorrect installation, which is not
covered by the product's warranty
(Figs. 4 and 5).
Installation above a cupboard unit
25mm
30mm
5 10mm
Fig.4
Installation above an oven unit
Minimum
10mm
500 x 20mm
Fig.5
500x10mm
÷
500 x 10mm
5 10mm ÷
25