CDA HN6850FR Manual page 10

Please note: Any zones that are still hot to the touch will display an
" " or " " provided the mains power supply is not interrupted.
Booster
The hob is equipped with a booster function on all zones, allowing a
higher power level than the maximum for approximately ten minutes.
To activate the booster on a zone
• Touch the desired zone's indicator (7) and then touch the booster
function sensor (4). "P" will show in the cooking zone indicator to show
that the booster is on.
• The booster function automatically deactivates after 10 minutes of
usage. The cooking zone will continue to operate at its nominal
power at this point. The booster can be reactivated after this time
provided the hob's internal components have not overheated.
To deactivate the booster on a zone
• To cancel the booster at any time, touch the desired zone's
indicator (7) and then use the heat setting slider sensor (5) to return
the heat setting to "0". Alternatively, press and hold the zone's
indicator for approximately 3 seconds to deactivate the zone.
Please note: The booster function can be used on a pair of bridged
cooking zones at the same time. However the booster function cannot
be used on more than two zones (or one bridge) at once. This is to
prevent damage to the internal components which may be caused by
overheating.
10