Belkin G User Manual page 17

F5D9231-4_V1000_G+MIMO_RTR_MNL-CLEAN.doc
Page 17 of 111
Step 1: Hardware Connections
(QIG)
[Must follow N Wireless Router QIG for the correct line art]
A. Unplug your modem's power cord. Put the Router next to the
modem. Raise the Router's antennas.
[insert line art from QIG]
B. Locate the networking cable that connects your modem and
computer. Unplug that cable from your modem, and plug it into any
gray port on the back of the Router.
[insert line art from QIG]
C. Find your new networking cable (included in the box with your
Router) and connect it to the yellow port on the back of the Router.
Connect the other end to your modem, in the port that's now free.
[insert line art from QIG]
D. Plug in your modem's power cord. Wait 60 seconds for the modem
to start up. Plug the Router's power supply into the black port on
the back. Plug the other end into the wall outlet.
[insert line art from QIG]
E. Wait 20 seconds for the Router to start up. Look at the display on
the front of the Router. Make sure the "Wired" and "Router" icons
are lit up in blue. If they are not, recheck your connections.
[insert lineart from QIG]
Step 2: Set Up the Router – Run the Setup Assistant Software
A. Shut down any programs that are running on your computer at this time.
Turn off any firewall or Internet-connection-sharing software on your
computer.
B. Insert the CD into your computer. The Setup Assistant will automatically
appear on your computer's screen within 15 seconds. Click on "Go" to run
the Setup Assistant. Follow the instructions there.
Follow the Quick Installation Guide
–