Belkin G User Manual page 15

F5D9231-4_V1000_G+MIMO_RTR_MNL-CLEAN.doc
Page 15 of 111
Connect your wired (non-wireless) computers to these ports. These ports
are RJ45, 10/100 auto-negotiation, auto-uplinking ports for standard UTP
category 5 or 6 Ethernet cable. The ports are labeled 1 through 4.
I. Connection to Modem (insert N Wireless Router Modem icon) –
Yellow
This port is for connection to your cable or DSL modem. Use the cable
that was provided with the modem to connect the modem to this port. Use
of a cable other than the one supplied with the cable modem may not work
properly.
J. Reset Button – Red
The "Reset" button is used in rare cases when the Router may function
improperly. Resetting the Router will restore the Router's normal operation
while maintaining the programmed settings. You can also restore the
factory default settings by using the "Reset" button. Use the restore option
in instances where you may have forgotten your custom password.
i. Resetting the Router
Push and release the "Reset" button. The lights on the Router
will momentarily flash. The "Power/Ready" light will begin to
blink. When the "Power/Ready" light becomes solid again, the
reset is complete.
ii. Restoring the Factory Defaults
Press and hold the "Reset" button for at least 10 seconds,
then release it. The lights on the Router will momentarily flash.
The "Power/Ready" light will begin to blink. When the
– Gray