How To Change Settings Of Service Programs - Ricoh VT2100 Series Operating Instructions Manual

CHANGING DEFAULT SETTINGS (SERVICE PROGRAM MODE)

How To Change Settings of Service Programs

You can register SP No. 5, 20, 29, 84 or 88 and their setting in the CS Mode
key ( see page 96).
Procedure 1
After entering the desired SP No.,
1
press the Enter key. The value or
mode set at the factory will be
displayed at the end of the sec-
ond line on the guidance display.
If you designate the wrong SP No.,
press the Clear Modes key. Then,
re-enter the desired SP No..
Enter the required value or mode
2
using the Number keys.
For the setting of each SP No.,
see page 102 ~ 107.
.
Press the Enter key to store the
3
desired value or mode.
If you enter the wrong value or
mode, press the Clear Modes key.
Then, go back to step 1.
95