Partial Copying - Ricoh FW740 Manual

PARTIAL COPYING

The Partial Copy function copies only a part of an original.
You need to enter start and end points in the original feed direction.
original
Notes
p You cannot use the Partial Copying function using the Rear Table.
p You cannot use the Partial Copying function for originals shorter than 255 mm.
p If you set the start point within 155 mm from the leading edge of the original, the copier will
regard the leading edge as the start point.
p The minimum available space between the start point and the end point is 30 mm.
p If you do not set the end point after setting the start point, the copier will regard the trailing edge
of the original as the end point.
p If you set the start point within 40 mm from the trailing edge of the original, the copier will
cancel the copying and exit the original.
p If you set the end point within 40 mm from the trailing edge of the original, the copier will regard
the trailing edge as the end point.
p In the Synchro Cutting function, the copier will cut the paper in a length from the start point to
the end point.
p When selecting the Partial Copying function, the copier will reset the settings for the trailing
edge margin, the leading edge margin in the Synchro Cutting function, and the Repeated Copy-
ing function.
1 Hold down the Function Select key for three
seconds.
A "P" will blink in the copy counter display.
a
Synchro Cut Mode
b
Bypass Table
Preset/Variable Cut Mode
Paper Length
Cut Select
Synchro
Preset/
Variable
Preset Cut
Leading Edge
Trailing Edge
Copy Counter
Bypass Select/
Function Select Roll Paper Cut
31