Rear Panel Connectors - Vertex Standard VXR-9000-H Operating Manual

R P
EAR ANEL
TX
Backup Power Source Terminals
If available, a backup 13.6 Volt power source, such
as a rechargeable battery, may be connected here.
When the Battery Charge switch (located on the PA
Unit) is set to "ON," a "trickle" charge current is
present here while the repeater is operating from
the "Main Power Source."
Circuit Protection Fuse
Two 15-Amp blade fuses, for the "Main" and
"Backup" power sources, are installed here.
RX Antenna Jack
This BNC-type coaxial jack accepts the receiver in-
put signal, for connection to the receiving antenna,
or the "RX" jack on the duplexer. The input imped-
ance requirement is 50 Ohms.
TX Antenna Jack
This N-type coaxial jack provides the transmitter
output signal, for connection to the transmitting
antenna, or the "TX" jack on the duplexer. The out-
put impedance requirement is 50 Ohms.
6
C
ONNECTORS
BACKUP
RX
MAIN
BACKUP
INPUT
DC 13.6V
EXT
ACC
Main Power Source Connector
The primary DC power source should be connected
here. The power requirements are 13.6 V DC at 12
Amps, continuous duty.
External Speaker Jack
This 3.5-mm, 2-pin jack provides variable audio
output for an external speaker. The audio output
impedance at this jack is 4 to 16 Ohms, and the level
varies according to the setting of the front panel's
VOL knob.
DSUB 25-pin Accessory Connector
This DB-25F connector allows the repeater to be re-
mote-controlled by an external controller. Analog
I/O signals, such as TX Audio In, Discriminator
Output, RSSI, etc. are available. Moreover, the VXR-
9000 provides eight ports that can be programmed
for various input or output signals, or for control
functions. Each port may be programmed as to its
function, its status (input or output), and its logic
(for output ports only).
VXR-9000 FM R
FCC ID: K6610443250/IC ID: 511B-10443250
GND
O
EPEATER PERATING
M
ANUAL
Vertex Standard Co., Ltd.