Vertex Standard VXR-9000-H Operating Manual page 7

Rack mount repeater
Table of Contents

Advertisement

P
S
CAN
Press (or Press and hold in for one second) the PF key
assigned to "Scan" to start scanning. To stop scanning,
press (or Press and hold in for one second) this key again.
The scanning feature is used to monitor multiple chan-
nels programmed into the repeater.
This function is only activated on the "Base Trans-
ceiver" mode.
S
QUELCH
Press (or Press and hold in for one second) the PF key
assigned to "Squelch" to override the Squelch action
(CTCSS, DCS, and Noise Squelch), so as to hear any sig-
nal present on the operating channel.
T
T
EST
ONE
Press (or Press and hold in for one second) the PF key
assigned to "Test Tone" to generate the Test Tone Signal,
as programmed by your VERTEX STANDARD dealer.
Press (or Press and hold in for one second) this key again
to stop the generation of the Test Tone. This is a toggle
function.
Press (or Press and hold in for one second) this key while
press and holding the PTT switch to transmit the Test
Tone Signal, as programmed by your VERTEX STAN-
DARD dealer.
T
T
M
EST
ONE
This function provides momentary generation of the
above-referenced Test Tone signal, so long as the PF key
assigned to "Test Tone M" is pressed and held in.
Press this key while press and holding the PTT switch
to transmit the Test Tone Signal, as programmed by
your VERTEX STANDARD dealer.
VXR-9000 FM R
EPEATER
ROGRAMMABLE
O
M
PERATING
ANUAL
F
PF K
UNCTION
TOT
Press (or press and hold in one second) the PF key as-
signed to "TOT" to turn the Time-Out Timer feature
"On" or "Off" (toggle).
When the TOT feature is set to "On," the repeater will
return to the "Receive" mode automatically after a pre-
set time of continuous transmission (determined via
programming by your VERTEX STANDARD dealer).
T
RANSMIT
Press (or Press and hold in for one second) the PF key
assigned to "Transmit" to enable ("On") or disable
("Off") the transmission of the VXR-9000.
TX P
M
OWER
ID
Press (or Press and hold in one second) the PF key as-
signed to "TX Power Mid"to set the transmitter power
to the "Mid" level.
Press (or press and hold in one second) this key again to
return to the "Original" power level (determined via
programming by your VERTEX STANDARD dealer).
This function is ignored on the channel which is pro-
grammed to the transmitter power to the "Mid" or
"Low" level by your VERTEX STANDARD dealer.
TX P
L
OWER
OW
Press (or Press and hold in one second) the PF key as-
signed to "TX Power Low"to set the transmitter power
to the "Low" level.
Press (or press and hold in one second) this key again to
return to "Original" power level (determined via pro-
gramming by your VERTEX STANDARD dealer).
This function is ignored on the channel which is pro-
grammed to the transmitter power to the "Low" level
by your VERTEX STANDARD dealer.
FCC ID: K6610443250/IC ID: 511B-10443250
D
EY
ETAILS
5
Vertex Standard Co., Ltd.

Advertisement

Table of Contents
loading

Table of Contents