Table of Contents
Advertisement
2. Push the knob to the options for [SPEED CALCULATION].
3. Rotate the knob to select [AUTO] or [MANUAL] then push the knob. For [AUTO] go to
step 4. For [MANUAL], do as follows:
1) Rotate the knob to select the current value and push the knob.
2) Rotate the knob to set a value (0.1 - 99.0).
4. Push the knob to finish.
3.13 AUTO OPTION Menu
Other than Fantum Feedback
ADVANCED AUTO:
NET TOWING AUTO*: OFF
CSE AFTER REMOTE:
*: Not shown when BOAT TYPE is set
for "sailboat".
.
Item
[ADVANCED
The AUTO mode will maintain a set course, but
AUTO]
your vessel's course may be shifted by the
effects of tide and wind. To compensate for the
effects of tide and wind, set [ADVANCED AUTO]
to [ON]. Your NAVpilot must be connected to a
GPS navigator which outputs position data (Lati-
tude and Longitude) in CAN bus or NMEA 0183
format.
[NET TOW-
When a boat is towing fishing gear its stern is
ING AUTO]
"dragged " by the net. This causes the boat to
stray from its intended course. To keep the boat
on course, you need to adjust the trim manually,
which can be bothersome. If you do not want to
be bothered with trim adjustments, you can
enable the automatic towing function to have the
trim automatically adjusted. This feature is useful
for trawlers and purse seiners.
Not available for "boat type" "sailboat".
Note: [NET TOWING AUTO] is not shown in
case of Fantum Feedback
[CSE AFTER
Select the course to follow after a remote control-
REMOTE]
ler is operated. See the figure below.
Note: [CSE AFTER REMOTE] is not shown in
case of Fantum Feedback
TM
AUTO OPTION
ON
PRESENT COURSE
Description
AUTO
MANUAL
For Fantum Feedback
AUTO OPTION
ADVANCED AUTO:
TM
.
TM
.
3. INITIAL SETTINGS
TM
ON
Settings
[OFF], [ON]
[OFF], [ON]
[PREVIOUS COURSE],
[PRESENT COURSE]
3-33
Advertisement
Table of Contents
