Roip Quick Setup - Pulse ROIP-400 Operation Manual

ROIP Setup

Plug power Adapter (9v DC) into ROIP .

Connect one end of the Ethernet cable to the ROIP and other end to the
Computer / Laptop/ switch Hub.

Check LAN connection LED (Green Color) is glowing continuously. If
it's Blinking , check your Ethernet cable.
 4 Radios are respectively connected with one 400 ROIP .
RJ-45 connectors to connect radio set (RA1, RA2, RA3, RA4).

Connect RJ-45 part of interface cable at the radio connector end of the
ROIP . Connect the other end to the accessory port of the Radio Set .
 Attach Antenna to the Radio and fix it outside the building or room
at the roof. Power on the Radio.
 Take a walkie talkie-1 at the same channel/ frequency as of Radio
set-1 similar as all walkie talkie as per respective Radio's.
 Speak from the walkie talkie-1 Radio Set-1 should receive the sig-
nal and CSQ Led R1 (green color) at the front of the ROIP should
glow. Similarly speak from the mic of the Radio Set –1, walkie
talkie-1 should receive the signal.
 Setup another ROIP and Radio's and Walkie Talkie's in the similar
way.
5
Copyright 2017 @ Pulse Communication Systems Pvt. Ltd.
ROIP-400 Operation Manual
There are four