Roip Server Configuration; One Or More System At Same Location; One Or More System At Different Location - Pulse ROIP-400 Operation Manual

ROIP Server Configuration

One or More Systems at same location
If you are configuring multiple ROIPs at same location. i.e. office, build-
ing, shopping mall, etc , having local area network (LAN). You can con-
figure all ROIP in broadcast model. Follow the configuration as men-
tioned below for the same:
Configure you computer/ laptop IP as mentioned in "Computer IP

Configuration".
Open ROIP "IP Configuration Page" .

If LAN will be used dedicatedly for ROIP, then configure IP , sub-

net mask and Gateway.
You already have Server IP , Server IP is that IP on which the ROIP

Console software is configured.
Open "Server Config Setting" page

Connection port: Conn 1,2,3,4
Remote IP:
One or More Systems at different location
If you are configuring two or more ROIPs at locations far away from
each other or in separate LAN Connections, follow the configuration as
mentioned below:
Configure you computer/ laptop IP as mentioned in "Computer IP

Configuration".
Open ROIP "Remote IP Configuration Setting Page"

If direct Static/Public IP is provided for Internet Connection to

ROIP, then note down the IP Address (say R1), Subnet Mask (say
SM1), Gateway/ Router IP address (say GW1).
Note IP Address (IP1) same as R1.
Else if Internet Connection is being distributed to the Local Network

by a Router or a Server. Then take an IP Address in the LAN (say
IP1) not being used by any other system. Note down Router/
Gateway LAN IP Address (say GW1), and subnet mask of LAN (say
SM1).
Open "Server IP Configure" setting page

Remote IP:
* Server must be ON.
18
Server IP
Server Static IP at all Conn Port
Copyright 2017 @ Pulse Communication Systems Pvt. Ltd.
ROIP-400 Operation Manual