Dtmf Commands - Pulse ROIP-400 Operation Manual

ROIP-400 Operation Manual

DTMF COMMANDS:-

To Dial Any Command Press PTT Button of Hand Held Set and Press
the Keys as mentioned below that command and then release the PTT
Button. A Confirmation Tone (Alternate Beep) will be heard on Correct
Command or Command Accepted. A Reject Tone (Short or Long Beep)
will be heard on Error Command or Command Rejection.
1. INDIVIDUAL USER CALL COMMAND
Command: ID*
(Refer to User ID Table for ID of Different Locations or Call Operator)
2. PRE-DEFINED GROUP CALL COMMAND
Command: 20#GID#
(Refer to Group ID Table for Groups of Different Location or Call
Operator)
3. PRE-DEFINED LIMITED GROUP CALL COMMAND
Command: 2#GID#
(Refer to Group ID Table for Groups of Different Location or Call
Operator)
4. CUSTOM LIMITED GROUP CALL COMMAND
Command: 8#ID*ID*ID#
(Insert More Users in Command by Adding *ID before last #)
5. CUSTOM GROUP CALL COMMAND
Command: 28#ID*ID*ID#
(Insert More Users in Command by Adding *ID before last #)
6. DISCONNECT OPERATOR/USER/GROUP CALL
COMMAND
##
Command:
7. INDIVIDUAL INTERNAL PORT CALL WITHOUT SERVER
COMMAND
Command : 3#Port ID#
(Port ID are pre defined port 1 ID is 1, Port 2 ID is 2,Port 3 ID is 3 and Port 4
ID is 4).
8. INTERNAL GROUP CALL WITHOUT SERVER COMMAND
Command : 4#GID#
(Group ID are pre defined Group 1 ID is 1, Group 2 ID is 2, Group 3 ID is 3
and Group 4 ID is 4)
Note: Make groups Using ROIP web page "Radio Group Config"
Copyright 2017 @ Pulse Communication Systems Pvt. Ltd.
25