Two Systems At Same Location - Pulse ROIP-400 Operation Manual

Two system at same location
If you are configuring two ROIP to be used in the same building,
office, shopping mall, etc such that the area is having a local area connec-
tion (LAN) between the two points where ROIP is to be setup, follow the
configuration as mentioned below:
Configure you computer/ laptop IP as mentioned in "Computer IP

Configuration".
Open ROIP "Local IP Configuration Page" .

If VLAN has been created for ROIP, then configure

IP Settings as below:
Local Ip :
Subnet Mask: 255.255.255.0
Gateway:
Open "Server Config Setting Page" and configure as below:

Connection port : Conn 1,2,3,4
Remote IP :
Else if LAN is also been used by other computers in the office, then

take two IP address in the same LAN which are not being used by
any system or computer (say IP1 and IP2). Confirm from the net-
work admin that the port "4040-4043" is not being blocked by the
firewalls.
If connecting ROIPs back to back with a single LAN Cable, then use

a Cross Cable.
If connecting to a switch/hub use a straight cable.

When both ROIP's connected to each other then link LED's L1/L2

& L3/L4 are constantly glowing.
17
ROIP 1
192.168.1.80
192.168.1.1
192.168.1.81
Copyright 2017 @ Pulse Communication Systems Pvt. Ltd
ROIP-400 Operation Manual
ROIP2
192.168.1.81
255.255.255.0
192.168.1.1
Conn 1,2,3,4
192.168.1.80
.