System Configuration; Point To Point Configuration; Two Or More Systems At Different Locations - Pulse ROIP-400 Operation Manual

SYSTEM CONFIGURATION

Point to Point Configuration

Two Systems at different locations
If you are configuring two or more ROIPs at locations far away from
each other or in separate LAN Connections, follow the configuration
as mentioned below:
Configure you computer/ laptop IP as mentioned in "Computer IP

Configuration".
Open ROIP "Local IP Configuration Page"

If direct Static/Public IP is provided for Internet Connection to

ROIP, then note down the IP Address (say R1), Subnet Mask (say
SM1), Gateway/ Router IP address (say GW1).
Note IP Address (IP1) same as R1.
Else if Internet Connection is being distributed to the Local Net-

work by a Router . Then take an IP Address in the LAN (say IP1)
not being used by any other system. Note down Router/Gateway
LAN IP Address (say GW1), and subnet mask of LAN (say SM1).
Also note down WAN/Public IP of the Router (say R1). To find out
Router WAN IP address, please see "WAN IP Locator". Or
contact your network admin. If R1 is dynamic assigned IP
Address, then note R1 as "0.0.0.0".
Similarly follow for other ROIP and note IP Address as (R2, IP2,

SM2, GW2).
Server Config Setting ROIP IP Settings as mentioned below:

Connection Port: conn 1,2,3,4
Remote IP:
Put the Router IP at all connection ports respectively.
If Internet Connection is being distributed to LAN by a Router or

server, then ask Network Admin to unblock Local Port and Remote
Port (mentioned in ROIP IP Settings), if blocked. Also ask forward
Port Address (Local Port) to IP Address of ROIP (IP1 or IP2)
Using Port Forward (NAT) feature or DMZ Host feature available
at Router or Server's Settings Page.
16
ROIP 1
R2
Copyright 2017 @ Pulse Communication Systems Pvt. Ltd.
ROIP-400 Operation Manual
ROIP2
conn 1,2,3,4
R1