Operation Steps（Fixed Temp Operation - Yamato DKG610 Instruction Manual

How to start
temp operation
MEASURED TEMP.
HEATER
ALARM ℃
AUTO STOP
AUTO START
SET
TEMP.
FIXED TEMP.
PROGRAM
OVER TEMP.
PROTECTOR
MEASURED TEMP.
HEATER
ALARM ℃
AUTO STOP
AUTO START SET
TEMP.
FIXED TEMP.
PROGRAM
OVER TEMP .
PROTECTOR
RUN
ENTER
STOP
FIXED SUB
TIMER PROGRAM
MENU
TEMP.
MEASURED TEMP.
HEATER
ALARM ℃
AUTO STOP
AUTO START
SET
TEMP.
FIXED TEMP.
PROGRAM
OVER TEMP .
PROTECTOR
RUN
ENTER
STOP
FIXED SUB
TIMER PROGRAM
TEMP. MENU
MEASURED TEMP.
HEATER
ALARM ℃
AUTO STOP
AUTO START
SET
TEMP.
FIXED TEMP.
PROGRAM OVER TEMP .
PROTECTOR
RUN
ENTER
STOP
FIXED SUB
TIMER PROGRAM
TEMP. MENU
If you want to correct
wrong settings or to
check settings
1.Turn power on（Turn ELB ON）
fixed
When you turn power on, the initial values will be displayed for
about four seconds and the screen will change to the initial setting
screen, and each of indicators displays the current in-bath
temperature, operation mode characters, and overheat prevention
set temperature.
Measured temp indicator：Displays the current in-bath temperature or
characters.
Set temp indicator：Displays the set temperature or characters.
Overheat preventive set temp indicator：Displays the set temperature
of the overheat preventive device.
For operation mode characters, see P.14.
2.Select an operation mode
Press FIXED TEMP.
Temp operation on the set temperature indicator.
3.Set a temperature
Press
FIXED TEMP.
Display the character Sv
on the measured temperature indicator, the current set temperature
flashes on the set temperature indicator and the fixed temp
operation lamp flashes.
▽ and △
Use
4. Start operation
Press
RUN/STOP
the Fixed Temp operation lamp will change from flashing to be lit.
5.Stop operation
Press
RUN/STOP
Fixed Temp operation lamp goes off and the screen switches to the
initial setting screen.
When you want to correct wrong settings or to check settings again,
press FIXED TEMP.
When you want to change the set temperature during operation, keep
FIXED TEMP.
changes, press
4.Operating Procedures
Operation steps（Fixed temp operation）
key to display Fix
key again.
keys to set a temperature you want.
key for about one second. Operation starts and
key for about one second. Operations stops, the
key and make settings again.
key pressed to enter to the setting mode. After making
key to complete setting.
ENTER
20
that means Fixed
that means temperature setting