Table of Contents
Advertisement
Installation
3.2 Installation Checklist
Table 3.1 provides an installation checklist for installing, wiring, and testing the XLS140 system. It
has references to installation information included in manuals listed in Section 1.2 "Supplemental
Documentation".
Seq
Task
1.
Mount the cabinet backbox to the wall.
2.
Install all required chassis in cabinet.
3.
Install control panel onto chassis.
4.
Optional: Install auxiliary power supply and/or external
battery charger
5.
Calculate the proper battery rating.
6.
Connect AC wiring, place batteries into backbox without
connecting them, and run cable to optional power supplies,
DC power outputs, NACs, and relays.
CAUTION: Do not apply AC or DC power at this time.
7.
Set switches for backup alarm (SW6-SW9).
8.
Optional: Install and wire Auxiliary Relay Module (ARM-4).
9.
Optional: Install Panel Circuit Modules (ICM-4RK,
CRM-4RK, VCM-4RK, DCM-4RK) and Voice Alarm System
components (AMG-1, FFT-7, Audio Amplifiers)
10.
Optional: Install output devices such as a printer, or CRT
terminal.
11.
Optional: Install XLS-NCA.
12.
Secure any unused mounting holes in control panel circuit
board.
13.
Wire the Signaling Line Circuits.
14.
Connect wire shielding as instructed.
15.
Apply AC power to the control panel by placing the external circuit breaker to the ON position.
Do NOT connect batteries.
16.
Check AC power.
17.
Connect the batteries using interconnect cable, P/N 75560 and 75561.
18.
Install the CAB-4 series door.
19.
Program the control panel.
20.
Field test the system.
3.3 Mounting a Cabinet
This section provides instructions for mounting a CAB-4 Series backbox to a wall. Follow these
guidelines when mounting the backbox:
•
Locate the backbox so that the top edge is 66 inches (1.6764 m) above the surface of the
finished floor.
•
Access to the cabinet shall be provided in accordance with NFPA 90, article 110.33.
•
Allow sufficient clearance around cabinet for door to swing freely. (See Section 2.3 "System
Cabinets".)
•
Use the four holes in the back surface of the backbox to provide secure mounting. (See
Figure 3.1.)
30
Refer to
Section 3.3 "Mounting a Cabinet"
Section 3.5 "Installing the Control Panel"
Section 3.5.1 "Control Panel Circuit Board & Keypad/
Display Unit"
Auxiliary power manuals
Appendix A "Power Supply Calculations"
Section 3.6 "Connecting the Power Cables"
Section 3.9 "Backup-Alarm Switches"
Section 3.13 "Auxiliary Relay Module (ARM-4):
Product-Specific Details"
Section 3.12 "Installing Panel Circuit Modules", and Voice
Alarm System Manual
Section 3.14 "Installing Remote Printers and/or CRT"
XLS-NCA Manual
Figure 3.4
Section 3.15 "Wiring a Signaling Line Circuit (SLC)"
SLC Wiring Manual
Table 3.3 in Section 3.6 "Connecting the Power Cables"
CAB-3/CAB-4 Series
Cabinet Installation Document
XLS140 Programming Manual.
Section 5 "Testing the System"
Table 3.1 Installation Checklist
XLS140 Installation Manual Form Number 95-7673-3 P/N 51927:C 12/06/2005
Installation Checklist
Hide quick links:
Advertisement
Table of Contents
