Changing The Note Position Etc. Of The Recorded Data - Technics sx-PR604/M Operating Instructions Manual

Part IV
MEASURE INSERT
Insert specified measures at a specified point.
• The length of the performance accordingly increases by
the number of inserted measures.
1.
Specify the measures you wish to copy from
the source track.
• On the FROM side, specify the settings with the corre-
sponding buttons.
TRACK: Specify the track number you wish to copy the
measures from.
• This function does not work for the CHORD or
RHYTHM track in which the repeat function has been
stored.
• If ALL is selected, the measures are inserted in all
tracks at the same time.
FIRST MEAS: Specify the first measure to copy.
LAST MEAS: Specify the last measure to copy.
2.
Specify where you wish to insert the selected
measures.
• On the TO side, specify the settings with the correspond-
ing buttons.
TRACK: Specify the track number.
• Measures from the CHORD, RHYTHM or CONTROL
track can only be inserted in the same track.
START MEAS: Specify the start point to insert the selected
measures.
REPEAT: Specify the number of times the selected meas-
ures are to be repeated.
3.
Press the OK button.
• The confirmation display appears. Press the YES button
to execute the function, or press the NO button to cancel
the function.
• Note that if the END command is included in the source
data, it is also inserted. Any data following the END
command is not inserted.
Changing the note position etc. of the re-
corded data
You can change the note pitch and position etc. of recorded data.
Select the function
1.
On the SEQ MENU display, use the SONG
∨
and buttons to select the number of the
song. Then select RANGE EDIT.
• The display looks similar to the following.
82
QQTG0665
APC TO SMF CONVERT
When a sequence is recorded using AUTO PLAY CHORD,
the SEQUENCER data just contains a chord sequence on
one track. APC TO SMF CONVERT creates a sequencer file
in which the APC/CHORD/RHYTHM/CONTROL parts and
PIANO PERFORMANCE PADS (PR804) phrases are each
recorded on a separate track, allowing you to save the
sequence in standard MIDI File format for playback on other
instruments.
Use the TR L and M buttons to select the
1.
track you wish to convert.
• In the PART column, the part name currently assigned is
shown.
• In the DATA column, a check mark (√) indicates a track
in which data is stored.
• Tracks in which RHYTHM, CONTROL, APC and CHORD
parts are stored cannot be selected (– – – is shown).
2.
Use the APC/PAD
the parts you wish to convert.
• Parts that are set to OFF will not be converted.
3.
Press the CONVERT button.
• Note that after the conversion, the automatic accompa-
niment part data is cleared; if necessary, save this data
beforehand.
• A confirmation display appears.
4.
Press EXECUTE to continue with the conver-
sion, or press the CANCEL button is you wish
to discontinue.
• After the EXECUTE button is pressed, the conversion
begins. Conversion takes the same length of time as
playback.
• If you wish to discontinue the conversion process midway,
press the ABORT button.
∧
2.
On the RANGE EDIT display, select a function.
3.
Perform the editing procedures. (See below.)
• During the editing procedure, if the indicator for the
TEMPO/PROGRAM is lit, you can use the TEMPO/PRO-
GRAM for the editing function.
Sequencer
∧ ∨
and buttons to select