Naming; Panel Write - Technics sx-PR604/M Operating Instructions Manual

Part IV
SEQUENCER VOLUME
When playing the keyboard along with a recorded perform-
ance, you can adjust the total volume of all the playback parts
as one.
⇒ Use the APC/SEQUENCER VOLUME slide
control to adjust the volume.
APC/SEQUENCER
VOLUME
MAX
OFF
• Use this control to lower the volume of the recorded
playback parts when it is too loud relative to the volume
of your manual performance.
• The volume of all sounds other than your manual per-
formance—including PIANO PERFORMANCE PADS
(PR804), MIDI input, etc.—is lowered.

Naming

Here is the way to assign a name to your recorded song.
1.
On the SEQ MENU display use the SONG
∨
and buttons to select a song.
2.
Press the NAMING button.
• The display looks similar to the following.

Panel Write

You can change the panel status which is in effect at the beginning of the song. These are the settings which are recalled when
the SEQUENCER RESET button is pressed.
1.
On the SEQ MENU display, use the SONG
∨
and buttons to select the song number. Then
select PANEL WRITE.
• The display looks similar to the following.
2.
Use the panel buttons to change to the desired
panel settings.
• At the MAX position, the volume of the playback parts
correspond to their current settings; at the OFF position,
the volume is 0.
• The volume can be adjusted for each part. (Refer to page
31.)
• Except during SEQUENCER playback or DIRECT PLAY
of a disk, this slide control adjusts the total volume of all
the automatic accompaniment parts.
• During SEQUENCER recording, the volume is automat-
ically at its maximum regardless of the position of the
slide control. During playback, however, lowering the slide
control from the MAX position will lower the volume from
its recorded level. For this reason, the slide control should
normally be left in the MAX position.
∧
3.
Assign a name to the song.
• Press the ABC button to enter alphabetical characters.
While the SHIFT button is pressed, upper case letters are
entered.
• Press the 123 button to enter numbers, etc. While the
SHIFT button is pressed, you can enter symbols.
• Press the POSITION button to move the cursor.
• You can also use the TEMPO/PROGRAM dial to select
the characters.
• Press the INS button to enter a space at the cursor
position.
• Press the DEL button to erase the character at the cursor
position.
• Press the CLR button to erase the entire name.
• Press the →← button to center the name.
4.
Press the OK button.
∧
3.
Press the OK button.
• "COMPLETED!" is shown on the display.
• PANEL WRITE is automatically activated at the when you
start to record.
• For rhythm data, the data in the RHYTHM part has priority.
Sequencer
69
QQTG0665