Control Messages; Realtime Messages - Technics sx-PR604/M Operating Instructions Manual

Part XII

Control Messages

Enable or disable the exchange of various control data.
1.
On the MIDI MENU display, select CONTROL
MESSAGES.
• The display looks similar to the following.
• The CONTROL MESSAGES display consists of 3 pages.
Use the PAGE buttons to switch between pages.
Use the MESSAGE L and M buttons to select
2.
the control message.
3.
Use the OFF/ON buttons to specify on or off
for the control message.
ON: Data for the control operation is exchanged.
OFF: Data for the control operation is not exchanged.
• The BANK SELECT setting is effective only when PRG.
CHANGE is set to ON.
• The EFFECT & REVERB setting controls the DIGITAL
EFFECT, CHORUS, MULTI EFFECT and REVERB on/off.
• RPN is the general term for KEY SHIFT, TUNING, PITCH
BEND RANGE and MODULATION SENSITIVITY.

Realtime Messages

Enable or disable the exchange of START/STOP data (REALTIME COMMANDS), and select the CLOCK mode.
1.
On the MIDI MENU display, select REALTIME
MESSAGES.
• The display looks similar to the following.
2.
Use the buttons on the left side of the display
to select a function.
∧ ∨
3.
Use the and buttons to change the setting.
REALTIME COMMANDS
ON: Rhythm and SEQUENCER start/ stop, continue,
and song position pointer data can be transmitted/re-
ceived.
OFF: This data cannot be transmitted/received.
CLOCK
INTERNAL: This instrument's internal clock is used to
control the performance. The clock of the connected
equipment is disabled.
MIDI: The clock of the connected equipment is used to
control the performance. This instrument's clock is
disabled. (The tempo is displayed as " = – – –.")
• The CLOCK is set to INTERNAL when the power to this
instrument is turned on.
4.
Repeat steps 1 and 2 for each control as
desired.
4.
Repeat steps 2 and 3 for the other function if
desired.
MIDI
129
QQTG0665