Assembly (Pr804) - Technics sx-PR604/M Operating Instructions Manual

Assembly
(PR804)
Follow the steps below to assemble your Technics piano. Make sure you are using the correct parts and that they are in the correct direction.
•
At least 2 people are required for assembly.
•
To disassemble the piano, reverse the procedure.
1.
Remove the packing and take the parts out of the
carton. Confirm that all the parts on the printed list
are present.
2.
The following parts are in the screw kit.
Black screws (long) . . . . . . . . 2
Black screws (short) . . . . . . 12
Black screws (slim) . . . . . . . . 2
3.
Affix the pedal box to the speaker box.
Black screw (long)
4.
Affix the right and left side panels to the speaker
box.
5.
Place the piano body to the stand.
WARNING:
Avoid pinching your fingers.
Note 1
Holding the piano body at least
10 cm in from the edge, place it
on the stand so that it does not
fall off.
Note 2
If the piano body is placed too
far to the right or left, or to the
front or back, it will become
unstable.
138
QQTG0665
List
Black screw (slim)
Black screw (short)
6.
Secure the piano body to the stand.
(1)
Insert 2 screws in the left and right screw holes on the front un-
derside of the piano body, and turn each screw for 5 or 6 revolu-
tions to fix them temporarily. Set the piano body so that the
screws hitch over the side panels, and slide the piano body to fix
it's position.
(2)
Once the position is fixed, tighten the screws securely to fasten
the piano body.
7.
Connect the pedal cord, power cord and speaker
cord to the terminals.
With the ⇑ mark
upwards, insert the
plug fully.
(1)
Plug the pedal chord, power cord and speaker cord into the ter-
minals on the rear of the piano.
(2)
When the piano is in place, turn the adjuster to stabilize the
pedal box.
Confirm: After assembling, check these points.
• Are any parts left over?
➝
Check the assembly procedure again.
• Does the piano rattle when it is rocked?
➝
Make sure all the screws are securely tightened.
• Are the speaker cord and power cord firmly inserted?
➝
Check again.
• Is the plug of the pedal cord inserted as far into the connector
terminal as it will go?
➝
If it is not completely inserted, the sustain and other pedal
functions may not work.
• Does the pedal box move when the pedals are pressed?
➝
Turn the adjuster to stabilize the pedal box.
When the piano has been moved or transported, retighten the
screws securely.
Black screw
(short)
PEDAL IN
Adjuster