Table of Contents
Advertisement
--margin
--measure_time <time>
--eye_select <eye_sel>
--lane <lane_index>
--rx_error_injection
--mixer_offset0 <value>
--mixer_offset1 <value>
--show_mixers_offset
--rx_fec_histogram
--show_histogram
--clear_histogram
--yes
Examples:
Get info of <device>, <port_number>:
mstlink -d <device> -p <port_number>
Get info of <device>, <port_number> and BER Counters:
mstlink -d <device> -p <port_number> -c
Get info of <device>, <port_number> and Transmitter Parameters:
mstlink -d <device> -p <port_number> --show_serdes_tx
Configure Port State:
mstlink -d <device> -p <port_number> --port_state UP
Configure Port Speeds:
mstlink -d <device> -p <port_number> --speeds 25G,50G,100G
--rx_amplitude <value>
Set Module Rx Output Amplitude
[0(100-400mV),1(300-600mV),2(400-800mV),3(600-1200
mV)]
Read the SerDes eye margins per lane
Measure time in seconds for single eye [10, 30, 60, 90,
120, 240, 480, 600 and 900] (Optional - Default 60 for
PCIe and 30 for Network ports)
Eye selection for PAM4 [UP, MID, DOWN, ALL] (Default
ALL)
Run eye for specific lane index (Default all lanes)
Enable the RX link deterioration
Fine change to the center of the eye [0x0 to 0x7ff]
Coarse change to the center of the eye [0x0 to 0x3ff]
Show mixer offset 0 and mixer offset 1
Provide histogram of FEC errors. The result is divided to
bins. Each bin is holding different number of errored bit
within FEC protected block
Show FEC errors histogram
Clears FEC errors histograms
Non-interactive mode, answer yes to all questions
76
Advertisement
Table of Contents
