Table of Contents
Advertisement
Internal Ref.
No.
2084837
Description: Setting the speeds (50GbE and 100GbE) for the new devices (Connect-X 6 and
above, Quantum switches and above) requires specifying the number of lanes for the
speed:
mstlink -d <dev> --speeds [50G_2X | 50G_1X | 100G_2X | 100G_4X]
For PRBS mode, to work with PAM4 speeds, use the same speed naming for (50GbE, and
100GbE).
Keywords: mstlink
Discovered in Version: 4.14.0-105
Fixed in Release: 4.16.0
2125012
Description: In case a device enters the livefish mode and all the information on the flash
including write-protected manufacturing information is lost, flint might not be able to
recover the device.
Keywords: mstflint
Discovered in Version: 4.14.0-105
Fixed in Release: 4.16.0
2151018
Description: Occasionally, when burning MFA2 using mstflint, it might get stuck if in the
middle of the process mstfwreset is executed.
Keywords: MFA2, mstflint
Discovered in Version: 4.15.0
Fixed in Release: 4.16.0
2193807
Description: Cable firmware burning capability is not supported.
Keywords: mlxcables
Discovered in Version: 4.15.0
Fixed in Release: 4.16.0
2319984
Description: Fixed an issue that caused the margin scan to fail with the following message:
Eye scan not completed.
Keywords: mstlink
Discovered in Version: 4.15.0
Fixed in Release: 4.16.0
Issue
118
Advertisement
Table of Contents
