Programming Instructions; Programming Filter/Circulation Pump; Programmable Filter/Heating Cycles (Economy Mode Only) - Sundance Spas ALTAMAR 880 User Manual

880 SERIES
13.0

Programming instructions

13.1

Programming Filter/Circulation Pump

The Sentry control system allows you to easily adjust two separate
aspects of filter/circulation pump operation:
• The time of day (start time) the filter/circulation pump turns on.
• The length of time (duration) the filter/circulation pump operates.
The factory default start time is 12:00AM (midnight). The default duration
is 12 hours. To make adjustments:
• Standard Mode - in this mode, press the
once;
• Economy Mode - in this mode, press the
times to enter the filter/circulation pump programming mode.
The LCD screen will display "Circ". At this time the system is ready to
accept your changes.
1. Press the (SeLeCT)
start time appears on the LCD display.
2. Press the (UP)
time in 30-minute increments.
3. Press the (SeLeCT)
4. Press the (UP)
duration time in 1 hour increments.
5. Press the (diSPLAY)
main water temperature display.
Note: If no button is pressed within 30 seconds, all changes are
recorded and the screen automatically returns to the standard water
temperature display. When the standard mode is selected (Section 12.3),
the filter/circulation pump automatically turns on for a heat call regardless
of the pump's programmed start time and duration.
13.2

Programmable Filter/Heating Cycles (economy Mode Only)

Your hot tub comes with four 30-minute filter cycles which activate the
filter/circulation pump while in economy mode. These cycles are factory
programmed to start at 6:00 AM, 12:00 (noon), 6:00 PM, and 12:00
(midnight). The control system allows you to easily adjust two separate
aspects of each cycle:
• The time of day at which it begins;
• The duration of the cycle.
Note: When "Economy" mode is selected (Section 12.3), the heater
activates only during a programmed filter cycle period. When a Summer
Logic condition is active (page 49), the filter/circulation pump will turn on
for all programmed filter cycles.
Page 48
button once. The previously programmed
or (dOWN)
buttons to program duration.
or (dOWN)
button to save changes and recall the
(CYCLe)
(CYCLe)
buttons to adjust the start
buttons to program the
button
button five