Activate Jets Pump 1; Activate Jets Pump 2/Pump 3; Light Button - Sundance Spas ALTAMAR 880 User Manual

A. Press and hold the WArMer (
B. Press and hold the jeTS 1 (
seconds. You will see the temperature rise to 106°F (41°C) on the LCD
display. To lower the temperature, press the COOLer (
C. When the overtemp has been activated, the white decimal point after
the last digit will flash on and off every second as an indicator for
being in the overtemp mode.
Note: Once the temperature goes below 104°F (40°C) and you would
like to raise the temperature to 106°F (41°C) again, you will have to
repeat the steps above.
11.4

Activate jets Pump 1

This button controls jets pump #1. Press once to turn on jets
pump #1. Press a second time to turn pump off.
11.5

Activate jets Pump 2/Pump 3

On two pump models, this button controls jets pump #2. Press
once to turn on jets pump #2. Press a second time to turn pump off.
On three pump Maxxus models, this button controls both jets
pump #2 and jets pump #3 in the following sequence:
1. Press once to turn on jets pump #2.
2. Press a second time to turn on jets pump #3.
3. Press a third time to turn off jets pump #2.
4. Press a fourth time to turn off jets pump #3.
Note: Anytime a jet pump has been manually activated, it will
automatically turn off after approximately 20 minutes. If at this time you
desire more jet operation you may simply turn the pump(s) back on.
11.6

Light Button

Pressing this button activates the footwell, waterfall and air
control LED lights in sequence as follows: High - Medium - Low - Off.
Note: Lights automatically turn off after 2 hours.
Anytime the light system has been manually activated, it
will automatically turn off after approximately 2 hours. If at
this time you desire more light operation, simply turn the
light system back on.
This button offers four light modes for your enjoyment. Press the
LIGHT MODE button to select our favorite lighting effect as follows:
) button then;
) button at the same time for 2
880 SERIES
) button.
Page 31