Table of Contents
Advertisement
DAT Autoloader Installation Manual
Removing the plastic spacer sheet (internal drive only)
The Scorpion 96 internal autoloader is shipped with a plastic
spacer beneath the autoloader drawer. To remove this sheet,
follow the instructions below.
1. Carefully turn the drive upside down and remove the two
2. Look on the back of the drive to find the tab at the end of
Figure 2. Removing front drawer retraints from the
internal autoloader
retaining screws, as shown in Figure 2.
the spacer. Pull slowly on this tab to slide the plastic
spacer out from between the drawer and the frame.
Remove the spacer and store it with the drive's shipping
materials.
Tab
Spacer
Note: Drive is shown
upside down
5
Advertisement
Table of Contents
