Table of Contents
Advertisement
DAT Autoloader Installation Manual
Dip switches on side of autoloader drawer (bank of four)
Figure 5 shows the bank of four dip switches located inside
the autoloader drawer, beneath a rubber plug.
With the drive powered on, open the autoloader drawer by
pressing the Open/Close button on the front bezel. After
setting the dip switches, press the Open/Close button to
close the drawer. You must power down the drive and restart
it before the new dip-switch settings will take effect.
As shown in the following table, these switches are used to
indicate the orientation of the display text and to enable or
disable autoloading of the first tape in a magazine.
Switch
Note. Before configuring these switches, you must
power-on the drive to open the magazine drawer.
Description
1
Drive display orientation
(OFF=horizontal; ON=vertical)
2
Autoload first tape on magazine
insertion (ON=enabled)
reserved
3
reserved
4
13
Default
OFF
OFF
OFF
OFF
Advertisement
Table of Contents
