Installing The Internal Autoloader; Configuring The Internal Autoloader; Default Settings - Seagate Scorpion 96 Installation Manual

6

3. Installing the internal autoloader

This chapter describes how to configure, mount, and attach
cables to the internal Scorpion 96 autoloader. For instructions
on installing an external autoloader, see Chapter 4, beginning
on page 16.

Configuring the internal autoloader

Before you install the internal version of the Scorpion 96 in
your computer, you may need to configure the drive to work
with your system.

Default settings

The default settings for the internal drive are listed below:
•
•
•
•
•
•
•
If these default settings are appropriate for your computer
system, then continue to "Mounting the internal autoloader"
on page 14.
SCSI termination is disabled.
SCSI terminator power is disabled.
The drive is set for SCSI ID 0.
MRS checking is enabled
(the drive will not read non-MRS tapes).
Parity checking is enabled.
Data compression is enabled.
Power-on self-test diagnostics are enabled.
DAT Autoloader Installation Manual