Seagate Scorpion 96 Installation Manual page 34

DAT Autoloader Installation Manual
display shows the word "OPERATOR." These and other
messages are summarized in the following table:
8-digit display messages
Message
0 TAPE
N TAPE
CHK MAG
CLEAN n
CLOSING
END MAG
EJECT n
EJECTING
ERASE n
ERROR x
LOAD n
OPENING
OPERATOR
READ n
READY n
REWIND n
SCANNING
Note. In the following table, the letter n indicates which
drive slot is affected. If no slot number is shown, a single
cartridge has been inserted.
Description
This message alternates with the CHK MAG message to
indicate that the magazine contains no cartridges.
After the drawer is closed, this message displays for 2
seconds. The variable N indicates the number of cartridges
in the magazine.
The cartridge is not correctly inserted in the magazine, or
the magazine contains no cartridges.
A cleaning cycle is occurring on the cartridge in slot n
The drawer is closing.
In sequential mode operation, the magazine is at its end.
The cartridge from slot n is being ejected from the drive.
The magazine is being ejected to the dismount position.
The cartridge from slot n is being erased.
A loader mechanism error occurred. See the following
table for an explanation of the errors.
The cartridge from slot n is being loaded and initialized.
The drawer is opening.
Operation action is required because a magazine is not in
place.
The cartridge from slot n is being read.
The cartridge from slot n is in the drive and the drive is
ready.
The cartridge from slot n is rewinding.
The magazine is being initialized.
27