Datamax Prodigy Plus Operator's Manual page 25

A STX L Command switches the Printer from the System Level to
the Label-Formatting Mode. All command characters after STX L
are interpreted as Label Formatting Commands until the Label-
Formatting Mode is terminated with the Command Character E, X
or s. All Label -Formatting Commands are terminated with hex
value 0D.
CC
Set cut by amount (4 digits)
:
The cutter function will perform a cutting
action after the number of labels specified
C Set column offset amount
c Set cut by amount (2 digits)
D Set height and width dot size
E Terminate label format and print label
G Place data in global register
H Enter heat setting
(The amount of heat applied per dot row,
can be used to help control print quality)
m Set metric mode
P Print speed
p Set label backup speed
Q Enter quantity of labels to print
R Set row offset amount
r Recall stored label format
S Slew (feed) speed
s Store label format in module
T Set field data line terminator
U Make previous field a string replace field
Prodigy Plus
Description
Table 2-4 Label-Formatting Commands
Printer Setup
:nnnn
nnnn = 4 digits of labels printed
before cut. Default = 0001
Cnnnn nnnn= in/100 or mm/10
cnn nn = 2 cut amount
h = Horiz. dot size; can be 1 or 2
v = Vert. dot size; can be 1,2, or 3
(0.005" steps) Default is "D22"
Hnn nn = 2 digits. 1 - 20
10 is nominal and default
The Printer must be reset in order
to return to standard measure
Px x = C -O (2 to 8 ips)
px x x = C -I (2 to 5 ips)
Qnnnn
Rnnnn
rnn...n
to 16 char. terminated by CR
Sx x = C - 0 (2 - 8ips)
sann...n a - destination module
nn...n - label name (16 char. max)
Tnn nn = 2 digit ASCII Hex
Format
nnnn = quantity
nnnn = in/100 or mm/10
nn...n Label name of up
A= Memory Module A
B =Memory Module B
C= Default Module
00 - FF
17