Datamax Prodigy Plus Operator's Manual page 137

Char
k Test RS-232 Port With a Y if OK
L Enter label formatting mode
M Set maximum label length
m Set metric flag, enter metric mode
n Clear metric flag, return to inch
mode
O Form edge offset (start of print
position)
o Cycle cutter
P Enter character dump mode
p Controlled pause
Q Clear all memory modules
q Clear module "q(A/B)"
R Ribbon Saver
r Select reflective sensor
S Feed rate
s Set for 1 dot buffer processing. Used
for full length dot buffer processing
T Printhead dot pattern test label
U Label format field replacement
V Software switch settings
v Firmware version information
W Request memory module Information Wa
w Test FLASH module memory
X Set default module bank
x Delete module file
Y Output sensor values
y Symbol set select
Z Print internal information and dot
pattern
z Pack module
Table 4-3 System Level Commands (Continued)
Prodigy Max Operator's Manual
Description Format
Sends character "Y" to RS-232 port
4 digits (nnnn) Max. 99.99 inch.
All measurements set to metric until reset
Onnnn nnnn = in/100 or mm/10
qa a = Module ID, upper case
Rx x = (Y/N) default = Dip switch or
front panel (Ribbon Saver Option only)
Used for "black-strip" media sensing, i.e.
continuous tags, butt-cut labels. Stripe
must be printed on back side of media
Sr r = C - W, 2.0 - 12.0 ips.
Vn n = 4 -label present, 2 -Internal batch
1 -Cutter enabled
Sends version string to Host
a = F -font, G -graphic, L -label
Takes about 90 seconds
Xa a = Memory Module ID, A or B
xMFname M = A/B module ID,
F = F,G,L file type
Sends sensor values status to RS-232 port
ySaa aa = Symbol set ID, see B-1
Za a = Memory Module ID, upper case
47