Cuing Up To Any Desired Position Set As Point A Or B - Sony HDV HVR-1500 Operating Instructions Manual

If you want to discard the changed value
Press the MENU button instead of pressing the SET
(YES) button to return to the menu display, then press
the MENU button again to end the menu operation
without saving the changed value into memory.
After the saving operation is completed, the monitor
screen and time counter display return to the REPEAT
FUNCTION setting display as shown in step 9.
14
To set point B, refer to steps 5 to 13.
(Select REPEAT END in step 5, B POINT in step 7,
and B PRESET in step 9.)
15
Press the MENU button to close the menu.
Cuing Up to Any Desired Position
Set as Point A or B
You can set any desired tape position as point A or B and
cue up to the set point when required.
Proceed as follows.
Cueing up to point A: Hold down the </A button, and
press the F FWD button or REW button.
Cueing up to point B: Hold down the ,/B button, and
press the F FWD button or REW button.
For the methods of setting points A and B, see "Setting the
current tape position as point A or B" (page 48).
50
Playback