Monitor Area; Arrow Buttons - Sony HDV HVR-1500 Operating Instructions Manual

n Monitor area
Displays the monitor video.
o Superimposed text information
Displays the text information and supplementary status
information set in the menu.
For details of superimposed text information, see
"Superimposed Text Information" (page 29).
4 Remote control switch/indicator section
1 Format indicators
a Format indicators
Indicates the tape format or input signal format during
recording or playback.
Indicator During playback During recording/E-E
HDV Lights when a
tape recorded in
HDV format is
played back.
DV Lights when a
tape recorded in
DV (SP) format is
played back.
DVCAM Lights when a
tape recorded in
DVCAM format is
played back.
Note
When a tape recorded in DVCPRO (25 Mbps) format is
played back, no indication appears here.
b Remote control switch
Select whether operation of this unit is controlled from the
front panel, or from an external device (using i.LINK or
RS-422A (9PIN) interface).
2 Remote control switch
LOCAL
9PIN
i.LINK
HDV DVCAM
(DV)
3 i.LINK format indicators
mode
Lights when the selected
input is i.LINK:HDV.
Lights when the REC
FORMAT menu item is set
to DV (SP), and one of the
following input is selected.
• Input other than i.LINK
• i.LINK:DV/DVCAM
Lights when the REC
FORMAT menu item is set
to DVCAM, and one of the
following input is selected.
• Input other than i.LINK
• i.LINK:DV/DVCAM
LOCAL: Operate from the front panel or a remote control
unit connected to the CONTROL-S connector
(SIRCS-compatible).
9PIN: Operate from an external device connected to the
REMOTE connector (9PIN) on the rear panel.
i.LINK: Operate from an external device connected to the
HDV/DV connector on the rear panel.
Note
When the remote control switch is set to 9PIN or i.LINK,
no tape transport control buttons other than the EJECT and
STOP buttons will work.
This can be changed with the LOCAL ENABLE menu
item (see page 74).
c i.LINK format indicators
These indicate the i.LINK input/output signal format.
HDV: Lights when an HDV 1080i format signal is input/
output through the i.LINK interface.
DVCAM (DV): Lights when a DVCAM/DV format
signal is input/output through the i.LINK interface.

5 Arrow buttons

M, m, </A, ,/B buttons
A
M, m, </A, ,/B buttons
Use these buttons to move around the menu items, and also
to set the initial timecode value and user bit data.
They can be used for search/variable-speed playback/
timecode display as follows.
• High-speed search playback
• Frame-by-frame playback
• Slow playback
For details of search playback operations, see "Variable
Speed Playback" (page 46).
• When points A and B are set for repeat playback:
Timecode display
Display the timecode of point
B in the time counter display
Display the timecode of point
A in the time counter display
B
Operation to carry out
Press the ,/B button.
Press the </A button.
Names and Functions of Parts
19