Panasonic PT-56DLX25 Service Manual page 42

PT-56DLX75 / PT-61DLX75
Reassembly Note for the Color Wheel Unit:
1) Install the Color Wheel Unit into the Optical Chassis using the 3 Bosses. Then install the CW Sponge so it covers the
Connector Cable.
CW Sponge
Connector
Cable
2) Pass the Connector Cable through the hook of the Optical Chassis CW Cover, then install the Optical Chassis CW Cover
with the 2 Screws (463).
Hook of Optical
Chassis CW Cover
Connector Cable
3) Hook and connect the Color Wheel F.P.C. to Connector PL3 so that the connecting terminal is facing front as shown below.
Then, hook and connect the Connector Cable to Connector PL2.
Connecting terminal
4) Place the Sheet on the Color Wheel F.P.C. (It is not necessary to place for servicing.)
5) After installing the Color Wheel Unit, be sure to perform the "Color Wheel Index Delay" adjustment.
6) Check the white balance on the screen. If NG, perform the "White Balance" adjustment.
Color Wheel Unit
Fig. P2-2
Fig. P2-3
Hook
PL2
Fig. P2-4
Optical Chassis
Bosses
Position of Color Wheel F.P.C.
Cushion
Color
Wheel
F.P.C.
Cushion
PL3
40
Place
Color Wheel
F.P.C. between
cushions.
Cushions
Sheet