After servicing, make sure that all wires, leads, and clampers are placed in their original position. It is important for the best
operation of the unit.
Note: Use extreme care especially for the following.
20-pin Cable
Clampers
GND Plate
PA1
(From Fan 3)
GND Wire
PL4
(From
PL2 (From Color Wheel C.B.A.)
Base
PL5
PL1 (20-pin Cable)
C.B.A.)
(From
(From Main C.B.A.)
Main
C.B.A.)
Clampers
<With Rear Shield Case and Fan 1 removed>
Fig. 9-3
15
Rear Shield Case
Fan 1
Clamper
Clampers
PL3 (From Color Wheel)
PT-56DLX75 / PT-61DLX75