Rewrite the MAC Address of the RF board
1. Connect a LAN cable and turn on the power after replacing the main
board (after a new MAC has been written to the main board).
2. Access the Commandexec Screen and perform the following command.
setblock wlan e3 01 12
Response OK
3. Access the Commandexec Screen and perform the following command
after more than 30 seconds after re-supply of power.
setblock wlan e1 10 4d4143206368616e6765
Response OK
4. Press the Factory Default Reset button.
* Do not turn the power off during execution of work.
5. Renew the MAC Address label.
10.15. IN CASE WHERE THE RF BOARD IS REPLACED
Rewrite the MAC Address of the RF board.
1. Connect a LAN cable and turn on the power after replacing the RF
board (after a old MAC has been written to the main board).
2. Access the Commandexec Screen and perform the following command.
setblock wlan e3 01 12
Response OK
3. Access the Commandexec Screen and perform the following command
after more than 30 seconds after re-supply of power.
setblock wlan e1 10 4d4143206368616e6765
Response OK
4. Press the Factory Default Reset button.
* Do not turn the power off during execution of work.
11. THE WAY OF THE INITIALIZE
11.1. FACTORY DEFAULT RESET BUTTON
The camera has a Factory Default Reset button on the rear.
67