FPI Hampton H15U-NG Owners & Installation Manual page 36

Direct vent gas fireplace
Table of Contents

Advertisement

WARNING!
Also check that the pilot and main
burner injectors
installation
are appropriate for the gas type.
11) Reassemble the black protection cap
12) Pull off the
(Fig. 6).
pilot cap to
expose the
pilot orifi ce.
13) Unscrew the pilot orifi ce with the allen
key and replace with the LP pilot orifi ce
in the kit.
Fig. 6
WARNING!
Also check that the pilot and main
burner injectors
are appropriate for the gas type.
12) Pull off the
14) Remove burner orifi ce with a 1/2"
pilot cap to
wrench and discard. Use another
expose the
wrench to hold on to the elbow behind
pilot orifi ce.
the orifi ce.
13) Unscrew the pilot orifi ce with the allen
key and replace with the LP pilot orifi ce
in the kit.
Burner Orifi ce
15) Reinstall new burner orifi ce LP stamped
Install the
#55 and tighten.
14) Remove burner orifi ce with a 1/2"
wrench and discard. Use another
wrench to hold on to the elbow behind
the orifi ce.
918-479
Burner Orifi ce
15) Reinstall new burner orifi ce LP stamped
#55 and tighten.
36
918-479
19) Remove the control panel by unscrewing
the 2 screws.
16) Reverse steps 3) to 2).
17) Attach the label "This unit has been
converted to LPG" near or on top of the
serial # decal.
18) Replace yellow "Natural Gas" label with
red "LPG" label.
20) First, remove the Piezo Ignition Wire
from the Piezo Ignitor. Then remove the
Piezo Ignitor from the control panel.
Installation of the DC Sparker:
19) Remove the control panel by unscrewing
the 2 screws.
21) Plug up the Piezo hole with the plastic
bushing.
20) First, remove the Piezo Ignition Wire
from the Piezo Ignitor. Then remove the
Piezo Ignitor from the control panel.
21) Plug up the Piezo hole with the plastic
bushing.
2
2
22) Attach the DC sparker generator
connector to the valve with a screw.
23) Remove the stove's rear panel by unscrew-
ing the two screws.
24) Attach the ground wire to the grounding
stud.
23) Remove the stove's rear panel by unscrew-
ing the two screws.
Before
24) Attach the ground wire to the grounding
stud.
After
Before
After
Hampton® H15U-NG/LP Direct Vent Freestanding Gas Stove
H15-1
04/21/06
04/21/06

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hampton h15u-lp

Table of Contents