Mounting And Wiring - BEA ULTIMO Manual

1
MOUNTING & WIRING
MOUNTING
1. Using the provided mounting template, mount the sensor centered over the clear opening*,
ensuring that the bottom of the sensor is no higher than 5 inches from the bottom of the
door header.
AUTOMATIC
AUTOMATIC CAUTION
CAUTION DOOR
DOOR
AUTOMATIC DOOR - STAND CLEAR
AUTOMATIC DOOR - STAND CLEAR
DUAL SLIDER
* Extreme left or right mounting is an option for single-sliders when
using IR:Width settings 4 or 5 (see page 12). Be sure that the edge
of the sensor is aligned with edge of the door header
2. Route the harness (20.5349) using the wire stay as shown.
• Sensor connectivity (power and relays) must utilize only the supplied harness.
• Sensor is intended to be monitored for proper operation by the door operator or system.
• Harness shall be routed separated from any Mains or non-Class 2 voltage cable for correct operation or
shall be rated for the Mains voltage, and suitable protection and routing means shall be used according to
National and Local Codes to prevent damage to the harness and/or sensor.
75.0034.03 ULTIMO 20220120
AUTOMATIC AUTOMATIC
CAUTION AUTOMATIC CAUTION AUTOMATIC
DOOR CAUTION DOOR CAUTION
DOOR DOOR
AUTOMATIC DOOR - STAND CLEAR AUTOMATIC DOOR - STAND CLEAR
AUTOMATIC DOOR - STAND CLEAR AUTOMATIC DOOR - STAND CLEAR
SINGLE SLIDER
AUTOMATIC
CAUTION
AUTOMATIC
CAUTION
DOOR
DOOR
AUTOMATIC DOOR - STAND CLEAR
AUTOMATIC DOOR - STAND CLEAR
Page 5 of 20