Mounting And Wiring - BEA IXIO-DT1 Manual

1
MOUNTING & WIRING
Use the provided mounting template and mount the sensor, ensuring that the bottom of the sensor is within 2
Route the harness using the harness clip as shown in the exploded view of the mounting illustration.
Mounting is compatible with the WIZARD.
Harness shall be routed separated from any Mains or non-Class 2 voltage cable for correct operation or shall be rated for the Mains
voltage, and suitable protection and routing means shall be used according to National and Local Codes to prevent damage to the harness.
2
RADAR OPENING IMPULSE FIELD
from 15° to 45°, default 30 °
13' x 6'6" (wide)
Page 4 of 9
inches of the bottom of the door header.
Sensor connectivity (power and relays) must utilize only the supplied harness.
Sensor power must be supplied from a Class 2 supply source limited to 15 W.
Sensor is intended to be monitored for proper operation by the door operator or system.
The size of the detection field varies according to the mounting height of the sensor.
The following graphics are representations - not default settings.
7.2 ft
field size: 9
immunity: 2
7.2 ft
1 × 1 grid is approximately 3.28 ft × 3.28 ft.
12-24 V AC, 50/60 Hz 12-24 V AC, 50/60 Hz
12-30 V DC 12-30 V DC
Max 2.5 W Max 2.5 W
* Output status when sensor is operational.
** The sensor LED will briefly flash RED during monitoring communinication
with door control. This indicates that external monitoring is functional.
Monitoring functionality must be active on the sensor and monitoring
wires must be properly connected to the door control.
field size: 9
immunity: 2
from -15° to 15°, default 0°
6'6" x 8' (narrow)
RED
POWER SUPPLY
BLACK
BROWN
SAFETY INPUT
BLUE
WHITE
OPENING INPUT
YELLOW
GREEN
PURPLE
TEST OUTPUT**
PURPLE
field size: 9
immunity: 2
7.2 ft
field size: 9
immunity: 2
7.2 ft
75.5751.11 IXIO-DT1 UL 20180305