Operation; Safe Operating Practices; Control Panel - HUSTLER X-ONE Operator's Manual

Safe Operating Practices

Refer to the Safety Precautions section of this manual for
operational and personal safety information.

Control Panel

Mowers without EFI engines
E
C
D
H
A. Fuel gauge
B. Hour meter
C. Throttle
D. Choke
E. Deck clutch switch
Figure 3-1
Mowers with EFI engines
E
A
I
H
A. Fuel gauge
B. Hour meter
C. Throttle
D. N/A
E. Deck clutch switch
F. Oil pressure light
Figure 3-2
606839
B
F
A
G
I
F. Oil pressure light
G. Ignition switch
H. 10 amp fuse
I. 20 amp fuse
B
F
J
F
C
G. Ignition switch
H. 10 amp fuse
I. 20 amp fuse
J. Engine malfunction
light

OPERATION

A. Fuel tank gauge (Figure 3-1, Figure 3-2 & Figure 3-3) —
this gauge shows the fuel level for each fuel tank. The
right gauge indicates the fuel in the right tank and the
left gauge indicates the fuel level in the left fuel tank.
B. Electronic
Figure 3-3) — registers 1/10 hour increments up to
9,999.9 total hours. It is connected to the ignition
switch. It records the accumulative time while the
ignition key is switched to the "RUN" position.
A
A. Fuel gauge - left tank
B. Fuel gauge - right tank
C. Throttle control (Figure 3-1 & Figure 3-2) — a cable is
linked to the engine throttle for controlling engine
speed. Move the lever forward to increase engine rpm,
move the lever rearward to decrease engine rpm.
D. Choke control (Figure 3-1) — a cable is linked to
manually operate the engine choke. When the lever is
in the down position, the choke is in the "OFF" (run)
position. When the knob is pulled up, the choke is in
the "ON" (start) position. Do not operate the machine
in the "ON" (start) position.
NOTE: The choke control is not used on mowers with
fuel injected engines.
E. Deck clutch switch (Figure 3-1 & Figure 3-2) — this
switch engages the deck. Pull the switch up to engage
and push switch down to disengage the clutch.
For additional clutch information refer to the Mower
Deck Operation section of this manual.
F. Oil pressure light (Figure 3-1 & Figure 3-2) — this light
comes on when the ignition switch is placed in the
"RUN" position and stays lit until the engine is running
and a safe oil pressure is developed. If the light comes
on during operation, shut the engine off immediately
and locate and correct the problem.
G. Ignition switch (Figure 3-1 & Figure 3-2) — a three
position switch: "OFF", "RUN", and "START". With key
inserted, rotate it clockwise to the "START" position;
3-1
hour meter (Figure 3-1,
C. Hour Meter
Figure 3-3
Figure 3-2 &
C
B
REV E