Table of Contents
Advertisement
Installation
Loose Parts
DESCRIPTION
Breaker
Bit–concrete breaker (other bits are available;
contact your Toro dealer for more information)
IMPORTANT: The Hydraulic Relief kit must
be installed on some traction units prior to
using the breaker or serious damage may
occur to the hydraulic system. Failure to
install the relief kit will void the warranty of
your traction unit. To determine if your
traction unit needs a Hydraulic Relief Kit,
contact your authorized Toro dealer.
Installing the Breaker on the
Traction Unit
IMPORTANT: Before installing the breaker,
ensure that the mount plates are free of any
dirt or debris.
1.
Position the breaker on a level surface with
enough space behind it to accommodate the
traction unit.
QTY.
1
Assemble the breaker
1
2.
Move pump control lever to slow (turtle)
position.
3.
Start the engine.
4.
Slowly push the attachment tilt lever forward to
tilt the attachment mount plate forward.
5.
Position mount plate into the upper lip of the
attachments receiver plate (Fig. 1).
2
1. Mount plate
6.
Raise the loader arms while tilting back the
mount plate at the same time.
IMPORTANT: The attachment should be
raised enough to clear the ground and the
mount plate tilted all the way back.
USE
1
Figure 1
2. Receiver plate
m–4055
5
Advertisement
Table of Contents
