Complete The Initial Configuration - Cisco Firepower 1010 Getting Started Manual

Complete the Initial Configuration

• (7.0 and later) Inside (Ethernet1/2 through 1/8)—https://192.168.95.1.You can connect to the inside
• (6.7 and earlier) Inside (Ethernet1/2 through 1/8)—https://192.168.1.1.You can connect to the inside
• (6.6 and later) Management—https://management_ip. The Management interface is a DHCP client, so
• (6.5 and earlier) Management—https://192.168.45.45. If you changed the Management IP address at
Step 2 Log in with the username admin, and thedefault password Admin123.
What to do next
• Run through the device manager setup wizard; see
Complete the Initial Configuration
Use the setup wizard when you first log into the device manager to complete the initial configuration. After
you complete the setup wizard, you should have a functioning device with a few basic policies in place:
• An outside (Ethernet1/1) and an inside interface. Ethernet1/2 through 1/8 are switch ports on the inside
• Security zones for the inside and outside interfaces.
• An access rule trusting all inside to outside traffic.
• An interface NAT rule that translates all inside to outside traffic to unique ports on the IP address of the
• A DHCP server running on the inside interface.
Note
Procedure
Step 1
You are prompted to read and accept the End User License Agreement and change the admin password.
You must complete these steps to continue.
Step 2 Configure the following options for the outside and management interfaces and click Next.
Cisco Firepower 1010 Getting Started Guide
100
address on any inside switch port (Ethernet1/2 through 1/8).
address on any inside switch port (Ethernet1/2 through 1/8).
the IP address depends on your DHCP server. If you changed the Management IP address at the CLI
setup, then enter that address.
the CLI setup, then enter that address.
VLAN1 interface (6.5 and later) or inside bridge group members on BVI1 (6.4).
outside interface.
If you performed the (Optional) Change Management Network Settings at the CLI, on page 97
then some of these tasks, specifically changing the admin password and configuring the outside and management
interfaces, should have already been completed.
Threat Defense Deployment with the Device Manager
Complete the Initial Configuration, on page 100.
procedure,