Cisco Firepower 1010 Getting Started Manual page 70

Register the Threat Defense with the Management Center
Figure 20: New Policy
• Smart Licensing—Assign the Smart Licenses you need for the features you want to deploy: Malware
(if you intend to use malware inspection), Threat (if you intend to use intrusion prevention), and URL
(if you intend to implement category-based URL filtering). Note: You can apply an Secure Client remote
access VPN license after you add the device, from the System > Licenses > Smart Licenses page.
• Unique NAT ID—Specify the NAT ID that you specified in the threat defense initial configuration.
• Transfer Packets—Allow the device to transfer packets to the management center. When events like
IPS or Snort are triggered with this option enabled, the device sends event metadata information and
packet data to the management center for inspection. If you disable it, only event information will be
sent to the management center, but packet data is not sent.
Step 3 Click Register, and confirm a successful registration.
If the registration succeeds, the device is added to the list. If it fails, you will see an error message. If the threat
defense fails to register, check the following items:
• Ping—Access the threat defense CLI, and ping the management center IP address using the following
command:
ping system ip_address
If the ping is not successful, check your network settings using the show network command. If you need
to change the threat defense Management IP address, use the configure network
management-data-interface command.
• Registration key, NAT ID, and management center IP address—Make sure you are using the same
registration key, and if used, NAT ID, on both devices. You can set the registration key and NAT ID on
the threat defense using the configure manager add command.
Cisco Firepower 1010 Getting Started Guide
68
Threat Defense Deployment with a Remote Management Center