Cisco Firepower 1010 Getting Started Manual page 51

Threat Defense Deployment with a Remote Management Center
Either the threat defense or management center needs a public IP address or hostname to allow to allow the
inbound management connection; you need to know this IP address for initial setup. You can also optionally
configure Dynamic DNS (DDNS) for the outside interface to accommodate changing DHCP IP assignments.
Figure 13:
Before You Start
Deploy and perform initial configuration of the management center. See the
Center 1600, 2600, and 4600 Hardware Installation Guide
Virtual Getting Started
End-to-End Procedure
See the following tasks to deploy the threat defense with management center on your chassis.
Guide.
Cisco Firepower Management
or Cisco Secure Firewall Management Center
Cisco Firepower 1010 Getting Started Guide
Before You Start
49