Cable The Device - Cisco Firepower 1010 Getting Started Manual

Cable the Device

Cable the Device
Figure 26: Cabling the Firepower 1010
Note
Note
Manage the Firepower 1010 on either Management 1/1 or Ethernet 1/2 through 1/8. The default configuration
also configures Ethernet1/1 as outside.
Procedure
Step 1 Install and familiarize yourself with your hardware using the
Step 2
Connect your management computer to one of the following interfaces:
• Ethernet 1/2 through 1/8—Connect your management computer directly to one of the inside switch ports
Cisco Firepower 1010 Getting Started Guide
94
For 6.7 and earlier, the inside IP address is 192.168.1.1.
For version 6.5 and earlier, the Management 1/1 default IP address is 192.168.45.45.
In version 6.5 and later, Ethernet1/2 through 1/8 are configured as hardware switch ports; PoE+ is also available
on Ethernet1/7 and 1/8. In version 6.4, Ethernet1/2 through 1/8 are configured as bridge group members
(software switch ports); PoE+ is not available. The initial cabling is the same for both versions.
(Ethernet 1/2 through 1/8). inside has a default IP address (192.168.95.1) and also runs a DHCP server
to provide IP addresses to clients (including the management computer), so make sure these settings do
not conflict with any existing inside network settings (see
Threat Defense Deployment with the Device Manager
hardware installation guide.
Default Configuration, on page 92).