Cisco Firepower 1010 Getting Started Manual page 68

Register the Threat Defense with the Management Center
Figure 19: License Search
Note
• Threat, Malware, and URL license combination:
• RA VPN—See the
Step 2
If you have not already done so, register the management center with the Smart Software Manager.
Registering requires you to generate a registration token in the Smart Software Manager. See the
center configuration guide
Assistance for Low-Touch Provisioning either when you register with the Smart Software Manager, or after
you register. See the System > Licenses > Smart Licenses page.
Register the Threat Defense with the Management Center
Register the threat defense to the management center.
Before you begin
• Gather the following information that you set in the threat defense initial configuration:
Procedure
Step 1 In the management center, choose Devices > Device Management.
Step 2
From the Add drop-down list, choose Add Device.
Cisco Firepower 1010 Getting Started Guide
66
If a PID is not found, you can add the PID manually to your order.
• L-FPR1010T-TMC=
When you add one of the above PIDs to your order, you can then choose a term-based subscription
corresponding with one of the following PIDs:
• L-FPR1010T-TMC-1Y
• L-FPR1010T-TMC-3Y
• L-FPR1010T-TMC-5Y
Cisco AnyConnect Ordering
for detailed instructions. For Low-Touch Provisioning, you must enable Cloud
• The threat defense management IP address or hostname, and NAT ID
• The management center registration key
Threat Defense Deployment with a Remote Management Center
Guide.
management