Complete The Initial Configuration - Cisco Firepower 1100 Started Manual

Complete the Initial Configuration

Before you begin
• Use a current version of Firefox, Chrome, Safari, Edge, or Internet Explorer.
Procedure
Step 1 Enter the following URL in your browser.
• (7.0 and later) Inside (Ethernet 1/2)—https://192.168.95.1.
• (6.7 and earlier) Inside (Ethernet 1/2)—https://192.168.1.1.
• (6.6 and later) Management—https://management_ip. The Management interface is a DHCP client, so
• (6.5 and earlier) Management—https://192.168.45.45. If you changed the Management IP address at
Step 2 Log in with the username admin, and thedefault password Admin123.
What to do next
• Run through the FDM setup wizard; see
Complete the Initial Configuration
Use the setup wizard when you first log into FDM to complete the initial configuration. After you complete
the setup wizard, you should have a functioning device with a few basic policies in place:
• An outside (Ethernet1/1) and an inside interface (Ethernet1/2).
• Security zones for the inside and outside interfaces.
• An access rule trusting all inside to outside traffic.
• An interface NAT rule that translates all inside to outside traffic to unique ports on the IP address of the
• A DHCP server running on the inside interface.
Note If you performed the
then some of these tasks, specifically changing the admin password and configuring the outside and management
interfaces, should have already been completed.
Cisco Firepower 1100 Getting Started Guide
70
the IP address depends on your DHCP server. If you changed the Management IP address at the CLI
setup, then enter that address.
the CLI setup, then enter that address.
outside interface.
(Optional) Change Management Network Settings at the CLI, on page 67
Firepower Threat Defense Deployment with FDM
Complete the Initial Configuration, on page 70.
procedure,