Settings - Festool OF 2200 EB-F Original Instructions Manual

English
Tool`s Ampere Rating
8-10
10-12
12-16
Wire Sizes in mm
2
Tool`s Ampere Rat­
ing
3-6
6-8
8-10
10-12
12-16
Use only NRTL listed extension cords.
Never use two extension cords together. In­
stead, use one long one.
The lower the AWG number, the stronger
the cord.
7.2 Switching on/off
The switch [2-2] is an on/off switch (press = ON,
release = OFF).
The on/off switch with the locking button [2-1]
can be engaged to operate in continuous mode.
Press the on/off switch again to release the
lock.
8

Settings

WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
8.1 Electronics
Speed control
You can continuously adjust the speed within
the speed range using the adjusting
wheel [1-11] (see "Technical data").
This enables you to optimise the cutting speed
to suit the respective material.
10
Cord Length in Feet
18 16 14 12
16 16 14 12
14 12 - -
Cord Length in Meters
15 30 60 120
0.75 0.75 1.5 2.5
0.75 1.0 2.5 4.0
0.75 1.0 2.5 4.0
1.0 2.5 4.0 -
- - - -
Mate­ Cutter diameter
rial
3/8" – 1-3/16"
1-3/16"
10–30
mm
Adjusting wheel setting
Hard­ 6–4
wood
Soft 6–5
wood
Coated 6–5
chip­
board
Plastic 6–4
Alumi­ 3–1
nium
Plas­ 2–1
ter­
board
Temperature cut-out
The power supply is restricted and the speed
reduced if the motor exceeds a certain temper­
ature. The power tool continues operating at re­
duced power to allow the ventilator to cool the
motor quickly. The power tool starts up again
automatically once the motor has cooled suffi­
ciently.
Restart protection
The built-in restart protection prevents the
power tool from starting up again automatically
if the power is disconnected when the on/off
switch is pressed. In this case, the power tool
must be switched off and then switched back on
again.
Due to the built-in restart protection, the power
tool cannot be switched on and off via an exter­
nal switch module.
Brake
The OF 2200 EB-F has an electronic brake
which brings the spindle with tool to a standstill
within approx. 2 seconds of the tool being
switched off.
Recom­
mended
2" –
cutting
– 2" 3-1/2"
material
30–50 50–89
mm mm
5–3 3–1 HW
(HSS)
6–4 5–3 HSS
(HW)
6–4 4–2 HW
6–3 3–1 HW
3–1 2–1 HSS
(HW)
1 1 HW