Technical Data; Parts Of The Device; Commissioning; Settings - Festool OFK 700 EQ Original Instructions Manual

The user is liable for improper or non-in­
tended use.
3.1 Routing tools
Type of feed
MAN (manual feed).
Speed
The maximum speed specified on the tool must
not be exceeded and the speed range must be
adhered to.
Materials
Wood, plastics. Observe the material informa­
tion on the packaging.
Only qualified and experienced persons who are
familiar with the tools are permitted to use
them.
4

Technical data

Edge router
Power
Speed
Max. speed (no-load)
Tool holder dia.
Max. routing diameter
Connection dia. d/e
Baseplate angle
Weight as per EPTA pro­
cedure 01:2014:
4.1 Routing tools
See imprint on the routing tool.
Cutters have been produced in compliance with
EN 847-1:2017.
5

Parts of the device

[1-1]
On/off switch
[1-2] Guide table
[1-3]
Auxiliary handle
[1-4] Handle
[1-5] Speed adjusting wheel
[1-6] Plug-it connection
The specified illustrations appear at the begin­
ning of the Operating Instructions.
6
Unauthorised voltage or frequency.
Risk of accidents
► The mains voltage and the frequency of the
power source must correspond to the
specifications on the name plate.
► In North America, only Festool machines
with the voltage specifications 120 V / 60 Hz
may be used.
Heating of the plug it connection if bayonet
fitting is not completely locked
Risk of burns
► Before switching on the power tool, make
sure that the bayonet fitting at the mains
OFK 700 EQ
cable is closed fully and locked.
720 W
► Connect and disconnect the mains power
cable [2].
10,000–
26,000 rpm
6.1
The switch [1-1] serves as an on/off switch (I =
26,000 rpm
ON, 0 = OFF).
6–8 mm
7
26 mm
27 mm
1.5°
Risk of injury, electric shock
2,2 kg
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
7.1
Constant speed
The preselected motor speed is kept constant
through electronic control. This ensures a uni­
form speed even when under load.
Speed control
You can use the adjusting wheel [1-5] to contin­
uously adjust the speed within the speed range
(see Section Technical data). This enables you
to optimise the speed to suit the respective ma­
terial. Please also note the specifications on the
tools.
Scorch or melt marks on the material can be
prevented through reducing the speed.
Restart protection
The built-in restart protection prevents the
power tool from starting up again automatically

Commissioning

WARNING
CAUTION
Switching on/off

Settings

WARNING
Electronics
English
15