Setting The System Setup - Sherwood Newcastle R-872 Operating Instructions Manual

SETTING THE SYSTEM SETUP

When selecting the items other than OSD
POSITION ADJUST
1.
Press the CURSOR UP(▲)/DOWN(▼) buttons
to select the desired item.
2.
Press the CURSOR LEFT(◀)/RIGHT(▶)
buttons to set the selected item as desired.
• AMP ASSIGN : To assign the surround back channels' power
amplifier correctly depending on how to use the
speakers.
• SUBWOOFER MODE : To select the desired subwoofer mode.
• HDMI AUDIO OUT : To output the digital audio signals from the
HDMI MONITOR OUT connector.
• TONE CONTROL : To adjust the tone (bass and treble) as
desired.
• CINEMA EQ : To select the desired cinema EQ mode.
• MOMENTARY OSD : To turn on or off the OSD that shows the
status corresponding to each operation
momentarily.
• OSD POSITION ADJUST : To adjust the position of the
When selecting the AMP ASSIGN
• The surround back channels' power amplifier can
drive the surround back speakers, the ROOM 2
speakers or the front bi-amp capable speakers.
Depending on how to use the speakers, you
should assign the power amplifier correctly. (For
details, refer to "CONNECTING SPEAKERS" on
page 11 and "CONNECTING ROOM 2 OUTS" on
page 13.)
BACK ← → ROOM 2 : When connecting this
BI - AMP : To drive the front bi-amp capable
SURR BACK : To drive the surround back
ROOM 2 : To drive the ROOM 2 speakers when
52
momentary OSD and the OSD menu.
receiver to the surround back
speakers and the ROOM 2 speakers
both, the power amplifier
automatically drives the surround
back speakers or the ROOM 2
speakers depending on whether the
ROOM 2 function is turned off or on.
speakers when connecting the FRONT
and the SURROUND BACK/MULTI
channels to them.
speakers when connecting the
SURROUND BACK/MULTI
channels to them.
connecting the ROOM 2 channels to
them. (" " lights up.)